Payment & Security
Your payment information is processed securely. We do not store credit card details nor have access to your credit card information.
Slip the pickup into the soundhole from the high E string side. (Loose the strings if it's too tight)
Clip both sides of the pickup to the edge of the panel.
Push the pickup to the end of the fingerboard as closer as possible.
- 1 x cross screwdriver
- 3 x Cable Holders
- 1 x Hexagonal adjusting rod
- 2 x fixtures leather pad
To place in guitar straps buckle a 12 mm diameter holes to install the pick-up tail nail, the holster pick-up end nails are removed, pin the tail with the hand out from hole to the outside of the guitar tighten nut (note: because the reinforcement plate thickness of the guitar is different so to adjust pick-up tail nail until appropriate) after good pick-up tail nail installation, arrange pick-up to stick with accessories in the ribs inside the guitar. To button pick-up lines, prevent making noise, loosen the clamp on both sides of the, put the pick-up in the sound hole position, every guitar string alignment between two head, then tighten the clamp.Finally, adjust the 12 according to the guitar head let a sensitive to the size of each string you need an ideal state.